Nikon LS-30 Bedienungsanleitung PDF herunterladen (Seite 19)

- 19 -

Setup: Installation

Once the scanner is installed, slide the front cover open. Using

a coin, remove the transport locking screws from the adapter

slot and side panel and screw them into the holes provided on

the rear panel. The adapter slot contains a plastic guard to

prevent the transport screw from falling into the scan mecha-

nism when the transport screw is removed. After removing the

transport screw from the adapter slot and screwing it into one

of the holes on the rear of the scanner, remove the guard and

store it in a safe place.

✔Caution: Never turn the scanner on with the locking screws

in place. Turning the power on in these circumstances could

damage the scanner.

Note: Replace the locking screws and guard when transporting

the scanner (see “Maintenance: Transporting the Scanner,”

below).

Transport locking screws

MADE IN JAPAN

100098

SCSI SCSI

SCSI NB

TERMINATOR

OFF ON

100–240V~

0.3–0.2A

50/60 Hz

Holes for locking screws

Guard

Coin

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 48 49

Keine Kommentare

Nikon LS-30 Bedienungsanleitung Seite 19