17Slide Feeder SF-200 (S)ContentsCautions ...
26Slide Mounts That Can Be Used in the SF-200 (S)• The following mounts have been tested and approved for use in the SF-200 (S):GEPE 3mm, GEPE 2mm, bo
274.2 Removing slidesSlides will be sent to the ejection magazine after scanning. To remove slides from the ejection magazine,pull back the push plat
28Open the SF-200 (S)’s magazine cover, pull back the feed push-plate to the end of its grove, and hookit in the notch so that it does not spring back
294.5 What to do if the feeder jamsIf a jam occurs, open the magazine cover and remove the slides remaining in the feed and eject maga-zines. Pull ba
30The attachment utility window will appear on the desktop. If more than one scanner is attached to yourcomputer and powered on, select the scanner t
315. MaintenanceThis chapter describes how to clean, store, and transport the SF-200 (S).5.1 CleaningBefore cleaning the feeder, remove it from the sc
326. SpecificationsFilm: 35 mm slide mount of 1.0 to 3.2 mm in thicknessMaximum number of slides: Approx. 50 slides with mounts 1.5 mm in thickness(Ho
18Cautions• The reproduction of this manual in whole or in part is prohibited save in cases in which Nikon’s priorpermission has been obtained.• The i
19Federal Communications Commission (FCC) Radio Frequency Interference StatementThis equipment has been tested and found to comply with the limits for
201. OverviewThank you for your purchase of an SF-200 (S) slide feeder for 4000 ED (SUPER COOLSCAN 4000 ED)and LS-2000 (SUPER COOLSCAN 2000) Nikon fil
21SF-200 (S) slide feeder (1)2. Parts and AccessoriesThis chapter lists the items packaged with your slide feeder and identifies the parts of the SF-2
223. InstallationBefore installing the SF-200 (S), make sure that your scanner is set up in a suitable location, as describedin the documentation prov
23The SF-200 (S) can be mounted on the scanner whether the scanner is off or on and connected to acomputer. If the scanner is on, before mounting the
24Close the magazine cover. You are now ready to begin scanning. For details on automatic consecutivescanning of multiple slides, refer to the softw
25• Do not load slides in the feed magazine past the load mark, as this may cause the feeder to jam.• Do not move the scanner while scanning is in pro
Kommentare zu diesen Handbüchern