Nikon LS-30 Bedienungsanleitung PDF herunterladen (Seite 16)

- 16 -

Parts and Accessories: Status LED

Status LED

The scanner’s status is shown by the LED on the front panel.

When the status LED is on and glowing steadily (READY):

the power is on but no operation is being performed.

Adapters

can be exchanged and film inserted. If the com-

puter to which the scanner is connected is off, the scanner

can be turned off.

When the status LED blinks slowly (BUSY):

scanning is in progress or the scanner is initializing after

having been turned on. Do not turn the scanner off, remove

or insert adapters, or eject or insert film.

When the status LED flashes rapidly (ERROR):

a communications error has occurred or there is a problem

with the scanner. If this condition persists, close all applica-

tions and turn off the computer, then turn off the scanner.

Wait at least five seconds before turning the scanner on

again and restarting the computer.

Status LED

Note: The LED may sometimes blink erratically, but this does

not indicate a malfunction.

✔Caution: Do not insert or remove adapters while the LED is

blinking, as this could cause the scanner to malfunction.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Keine Kommentare

Nikon LS-30 Bedienungsanleitung Seite 16