Nikon AX-210 Bedienungsanleitung PDF herunterladen (Seite 33)

Nikon

ScanTouch 210 User's Manual 23

4.4 Setting the SCSI ID

The SCSI ID for the ScanTouch 210 is set at “5” when the unit is

shipped. If other SCSI devices are connected to your computer, make

sure that the SCSI ID for the ScanTouch 210 is different from those

assigned to other SCSI devices.

Note that in the case of a host computer which has a built-in SCSI hard

disk or built-in CD-ROM, the ID numbers of the host CPU and each

SCSI device have already been assigned.

If the IDs are duplicated, you must change the ID number of the other

SCSI device or of the ScanTouch 210 to avoid any conflict.

Remarks

• To change the ID, confirm that the scanner power is off. The ID

cannot be changed when the power is on.

• Do not use SCSI ID 8 and 9 or A through F on your scanner. They

are for factory use only.

• As 7 has been assigned for the CPU and 0 has been assigned to the

built-in hard disk for a Macintosh, and 0 and 7 have also been

assigned to other personal computer systems, any number from 1 to

6 is recommended for the ID number.

• If conflicting ID numbers are assigned, your system might not

function, or important data on the hard disk might be destroyed. It

is therefore essential to check the ID numbers carefully before

connecting the scanner.

4. Connecting the Scanner

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 46 47

Keine Kommentare

Nikon AX-210 Bedienungsanleitung Seite 33