Nikon WP-N3 Bedienungsanleitung PDF herunterladen (Seite 57)

The Preliminary Leak Test

Before placing the camera in the case, latch the case and immerse it in

water to check for leaks as described below.

Important!

Before placing the camera in the case, be sure that the camera is functioning normally and

that the case does not leak. Failure to check for leaks before use could result in irreparable

damage to the camera. Note that leaks may result if the case is cracked or damaged. Check

the case for cracking and other damage before use, and consult with a Nikon-authorized

service representative in the event that any cracking or damage is found.

Latch and immerse the case.

Latch the case and then slowly immerse it in

water, stopping if air is expelled from inside

the case. Keep the case immersed for 2 or 3

seconds and check for bubbles escaping. Test

the case in a shallow area at a depth of about

1 m (3 ft) or in a tub or bucket. Do not use

hot water, as this could exceed the operating

temperature range of 0–40 °C (32–104 °F).

Test the controls.

Immerse the case and operate the controls

underwater for 2 to 3 minutes, checking

whether bubbles escape.

Check for water inside the case.

Take the case out of the water and dry it thor-

oughly with a soft, dry cloth, then open the

case and check for water. If water has entered

the case, check the O-ring (

15, 22–23). If the

cause of the leak can not be determined, take

the case to a Nikon-authorized service repre-

sentative.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 311 312

Keine Kommentare

Nikon WP-N3 Bedienungsanleitung Seite 57