Nikon R1 Bedienungsanleitung PDF herunterladen (Seite 31)

z Flash operation using the R1C1

Attaching the SB-R200 to the front of the lens.

Attach one of the Adapter Rings to

the front of the lens.

Five types of Adapter Rings with different

diameters (ø52mm, ø62mm, ø67mm,

ø72mm, and ø77mm) are provided.

• Turn the Adapter Ring securely until it stops.

• These rings cannot be used together with

other lens filters.

• AF Micro-Nikkor 105mm f/2.8D is shown in the

illustration.

Press the Attachment Ring SX-1’s

Mounting Buttons on both sides to

attach it to the Adapter Ring, then

release.

• Make sure that the Nikon logo (p. 24) on the

SX-1 is on the under side facing down.

• Use fingers of both hands to press the two

Mounting Buttons on both sides to attach the

SX-1 securely.

• Make sure that the SX-1 is not attached at an

angle. If it is, remove and reattach.

Slide the SB-R200’s Mounting Foot

into the SX-1’s Mounting Groove,

then slide the lock switch.

The Mounting Foot cannot be inserted in

reverse.

• Slide the lock switch until it stops and make

sure that the red part can no longer be seen.

Move the SB-R200 slowly by

holding down the Release Button

on the SB-R200’s Mounting Foot.

Remove your fingers at the desired

position to secure it.

There are click stops every 15° on the

Attachment Ring.

LOCKLOCK

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 133 134

Keine Kommentare

Nikon R1 Bedienungsanleitung Seite 31