Nikon WT-4 Bedienungsanleitung PDF herunterladen (Seite 8)

Notices

Notices for Customers in Canada

CAUTION : This class B digital apparatus complies with Canadian ICES-003.

ATTENTION : Cet appareil numerique de la classe B est conforme a la norme

NMB-003 du Canada.

❏ IC RSS-GEN Exposure of Humans to RF Fields

This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.

Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation of this

device.

This device has been designed to operate with an antenna having a maximum

gain of 2.1 dBi. Industry Canada regulations strictly prohibit antennas with

higher gain. The required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its

gain should be so chosen that the equivalent isotropically radiated power

(EIRP) is not more than that required for successful communication.

Co-location

This transmitter must not be co-located or operated in conjunction with any

other antenna or transmitter.

FCC/IC RF Exposure Statement

The available scientific evidence does not show that any health problems are

associated with using low power wireless devices. There is no proof, however,

that these low power wireless devices are absolutely safe. Low power Wireless

devices emit low levels of radio frequency energy (RF) in the microwave range

while being used. Whereas high levels of RF can produce health effects (by

heating tissue), exposure to low-level RF that does not produce heating effects

causes no known adverse health effects. Many studies of low-level RF

exposures have not found any biological effects. Some studies have suggested

that some biological effects might occur, but such findings have not been

confirmed by additional research. This Wireless Transmitter (WT-4A), which is

equipped with an SX-10WAG (FCC ID: N6C-SX10WAG / IC: 4908B-SX10WAG)

Wireless LAN Module, has been tested and found to comply with FCC radiation

exposure limits set forth for uncontrolled equipment and meets the FCC radio

frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of

the IC radio frequency (RF) Exposure rules. Please refer to the SAR test report

that was uploaded to FCC website.

This WT-4A has been tested and meets the FCC RF exposure guidelines when

used with the Nikon Corporation accessories supplied or designated for this

product. Use of other accessories may not ensure compliance with FCC RF

exposure guidelines.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 198 199

Keine Kommentare

Nikon WT-4 Bedienungsanleitung Seite 8