Nikon EH EL2 Bedienungsanleitung PDF herunterladen (Seite 8)

PREPARATION FOR USE

Installing the Battery

The exposure measurement and shutter control circuits

of the EL2 are powered by a single 6-volt (type 544)

battery mounted in the battery chamber at the bottom

of the mirror box. To install the battery, first remove

the lens (if mounted) from the camera body (see page

42) and lock up the mirror (turn the lockup lever

upward as far as it will go, as described on page 39) to

gain access to the battery chamber. Then, open the

battery chamber (slide the lid to the left, then up)

and install the battery, making sure to properly align

the positive (+) and negative (-) terminals of the

battery as depicted on the interior of the lid. After

inserting and properly seating the battery, snap the

chamber lid shut, unlock the mirror and remount the

lens preparatory to shooting.

Caution:

Should the battery be installed incorrectly (i.e., in the

reverse direction) in the chamber, its energy will be depleted in

a matter of minutes; thus, take extra care to insert the battery

properly. Also, be careful not to touch the shutter curtain and

mirror surface while installing the battery.

Note:

Remove the battery when the camera is not to be used

for a long period; this will prevent leakage within the camera.

Also,

keep the camera as warm as possible when operating

under cold-weather conditions; otherwise, the battery may fail

to function. (See "Tips on Camera Care" on page 40 for

additional information.)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

Keine Kommentare

Nikon EH EL2 Bedienungsanleitung Seite 8