
101
Troubleshooting
Appendices
Troubleshooting
Problem Solution Page
“POWER” LED does not
light.
• Turn the UT-1 on.
• Confirm that the battery is
inserted and fully charged.
33, 40, 60
10, 75
Network option not
available.
Confirm that the UT-1 is
connected and on.
31, 39, 58
Excessive radio
interference.
Adjust the position of the wireless
access point or host computer.
—
All LEDs flash at once.
UT-1 hardware or battery
malfunction. Contact a Nikon-
authorized service representative.
—
Camera displays TCP/IP or
FTP error.
• Check settings for host and/or
wireless LAN adapter and adjust
camera settings appropriately.
• Check firewall settings.
26, 52, 69
8
Camera displays wireless
error.
• Confirm that host and wireless
LAN adapter are on.
• Ensure that there are no
obstacles between UT-1 and
wireless LAN adapter.
• Check settings for host and/or
wireless LAN adapter and adjust
camera settings appropriately.
—
—
26, 52, 69
Camera displays “Ethernet
cable is not connected”.
Connect Ethernet cable or select
WT-5 (Wireless LAN) for Select
hardware.
19, 47, 99
Memory card error
displayed.
Confirm that memory card is
properly inserted.
—
Transfer interrupted
before all photographs are
sent.
Transfer will resume if UT-1 is
turned off and then on again.
35, 41, 63
USB cable disconnected
during transmission.
Reconnect the USB cable.
Do not
turn the camera off.
—
Kommentare zu diesen Handbüchern