Nikon VT695 Bedienungsanleitung PDF herunterladen (Seite 29)

3. Projecting an Image (Basic Operation)

Note on Startup screen (Menu Language Select screen)

When you first turn on the projector, you will get the Startup menu. This menu gives you the opportunity to select one

of the 8 menu languages.

To select a menu language, follow these steps:

1. Use the SELECT





button to select one of the 8

languages from the menu.

2. Press the ENTER button to execute the selection.

After this has been done, you can proceed to the menu op-

eration.

If you want, you can select the menu language later.

(→ [Language] on page 39 and 44)

NOTE: Immediately after turning on the projector, screen flicker may occur. This is normal. Wait 3 to 5 minutes until the lamp

lighting is stabilized.

When the Lamp mode is set to Eco, the LAMP indicator will light green.

If one of the following things happens, the projector will not turn on.

• If the internal temperature of the projector is too high, the projector detects abnormal high temperature. In this

condition the projector will not turn on to protect the internal system. If this happens, wait for the projector's internal

components to cool down.

• When the lamp reaches its end of usable life, the projector will not turn on. If this happens, replace the lamp.

• If the lamp fails to light, and if the STATUS indicator flashes on and off in a cycle of six times, wait a full minute and

then turn on the power.

ENTER

EXIT

MAGNIFY PAGE

OFF

POWER

PIC-MUTE

DOWN

SELECT

ENTER

EXIT

LAMP

STATUS

POWER

ON/STAND BY

AUTO ADJ.SOURCE

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 78 79

Keine Kommentare

Nikon VT695 Bedienungsanleitung Seite 29