Nikon VT695 Bedienungsanleitung PDF herunterladen (Seite 22)

2. Installation and Connections

When Viewing a DVI Digital Signal (VT695/VT595)

To project a DVI digital signal, be sure to connect the PC and the projector using a DVI cable (not supplied) before

turning on your PC or projector. Turn on the projector first and select Computer 2 (Digital) from the source menu

before turning on your PC.

Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should

this happen, restart your PC.

Do not disconnect the DVI cable while the projector is running. If the signal cable has been disconnected and then re-

connected, an image may not be correctly displayed. Should this happen, restart your PC.

NOTE:

• Use a DVI cable or the one compliant with DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0

standard. The DVI cable should be within 5 m (196") long. Both single and dual types of DVI cable can be used.

• The DVI (DIGITAL) connector accepts VGA (640x480), SVGA (800x600), 1152x864, XGA (1024x768) and SXGA (1280x1024 @

up to 60Hz).

AUDIO OUT

AUDIO IN

MONITOR OUT (COMP 1)

COMPUTER 1 IN

COMPUTER 2 (DVI-I) IN

AUDIO IN

S-VIDEO

VIDEO IN

PC CTRL

AUDIO IN

COMPUTER 2 (DVI-I) IN

PHONE

Audio cable (not supplied)

IBM PC or Compatibles (Desktop type)

or Macintosh (Desktop type)

DVI cable (not supplied)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 78 79

Keine Kommentare

Nikon VT695 Bedienungsanleitung Seite 22