Nikon MRDI Bedienungsanleitung PDF herunterladen (Seite 13)

SECTION 3

Camera Control

3.1 Quick Start with the Camera Link

Interface

Follow your Frame Grabber manufacturer’s instructions when inserting the frame grabber card into

your PC. Be sure that you install the correct configuration software that matches the camera that

you are using.

At this point your camera should already be connected to the DC power supply, and connected to

the frame grabber in your PC. Your frame grabber will see our camera and start communicating

almost immediately. As soon as your camera starts communicating with the frame grabber, you

can verify this fact by looking at your monitor and observing the video signal.

To communicate with your camera we have created specific commands. In the next section we will

go over these commands in detail.

3.2 Commands

Note: Commands are not case sensitive. To input commands, type in the three character

command and hit enter.

Command Syntax:

Command + enter, example: Type in RSH, then enter

Command + enter + value, example: Type in SSM then enter, then type 2

Command + enter + value + enter, example: Type in SLR then enter, then type 2000, then enter

RSH

This command allows you to perform a hard camera reboot.

The camera returns….………..…Reboot Started

RSS

This command allows you to perform a logic reset.

No return………………………….no message

INQ

This command will show you what camera is connected to your PC.

The camera returns…..………….Fairchild Imaging 2K CMOS

Fairchild Imaging • CAM/CMOS-2K.LS Line Scan Camera User’s Manual • Rev A • 13 of 41

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 40 41

Keine Kommentare

Nikon MRDI Bedienungsanleitung Seite 13