Nikon 18-55mm-f-35-56G-AF-S-DX-VR-Zoom-Nikko Bedienungsanleitung PDF herunterladen (Seite 16)

Vibration reduction mode (VR)

By enabling vibration reduction (VR), slower shutter

speeds (approximately three stops* at a focal length of

55mm) can be used. Panning is also supported. (*Based

on results achieved under Nikon measurement

conditions. The effects of vibration reduction may vary

according to shooting conditions and use.)

Turning vibration reduction on and off

Set the vibration reduction ON/OFF switch

Note: Be sure to set the switch 0 so that the

indicator is precisely aligned with ON.

Camera shake is reduced when the shutter-release

button is pressed halfway. Autofocus and manual

focusing, as well as precise framing of the subject,

are simplified because camera shake visible

through the viewfinder is also reduced.

To disable vibration reduction, set the vibration

reduction ON/OFF switch 0 to OFF.

Notes on using vibration reduction

• After pressing the shutter-release button halfway,

wait until the image in the viewfinder stabilizes

before pressing the shutter-release button the rest of

the way down.

• If the camera is panned in a wide arc, compensation

for camera shake in the panning direction is not

performed. For example, when panning the camera

in a horizontal direction, vertical camera shake is

reduced. This stabilizes the image whilst allowing the

desired panning effect to be realized.

• Due to the characteristics of the vibration reduction

mechanism, the image in the viewfinder may be

blurred after the shutter is released. This is not a

malfunction.

• Do not turn the camera off or remove the lens from

the camera while vibration reduction is operating.

Failure to observe this note could result in the lens

sounding and feeling as if an internal component is

loose or broken when it is shaken. This is not a

malfunction. Turn the camera on again to correct this.

• With cameras featuring a built-in flash, vibration

reduction does not function while the built-in flash is

charging.

• When the camera is mounted on a tripod, set the

vibration reduction ON/OFF switch 0 to OFF.

However, it is recommended that the switch be set to

ON when using the camera on an unsecured tripod

head or with monopod.

• With autofocus cameras such as D2-series and D300

models, featuring an AF-ON button, vibration

reduction does not function when the AF-ON button

is pressed.

Setting the aperture

Use the camera to adjust the aperture setting.

Variable maximum apertures

Zooming the lens from 18mm to 55mm decreases the

maximum aperture by 1

/3 stop.

However, the camera will compensate for any change

in aperture by adjusting the shutter speed so as to

maintain the correct exposure value.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare

Nikon 18-55mm-f-35-56G-AF-S-DX-VR-Zoom-Nikko Bedienungsanleitung Seite 16

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Linsen Nikon 18-55mm-f-35-56G-AF-S-DX-VR-Zoom-Nikko