Nikon D2Xs Bedienungsanleitung PDF herunterladen (Seite 281)

267

Technical Notes—Speciﬁ cations

If the Calibration Lamp Blinks

If the calibration lamp blinks for about ten seconds after a battery is inserted,

the battery needs to be calibrated to ensure that its charge state can be ac-

curately measured. The time needed to calibrate the battery is shown by the

charge lamps:

Approximate time

needed to recalibrate

battery

Calibration

lamp (yellow)

Charge lamps (green)

CAL ON 2 h 4 h 6 h

Over 6 hours

Glows Glows Glows Glows

4 – 6 hours

Glows Glows Glows Off

2 – 4 hours

Glows Glows Off Off

Under 2 hours

Glows Off Off Off

To start calibration, press the CAL button next to the calibration lamp for

about a second while the lamp is blinking. When calibration is complete, the

calibration and charge lamps will turn off and charging will begin.

Although calibration is recommended for accurate measurement of battery

charge state, calibration need not be performed when the calibration lamp

blinks. Once begun, calibration can be interrupted as desired.

• If the CAL button is not pressed while the calibration lamp is blinking, nor-

mal charging will begin after about ten seconds.

• To interrupt calibration, press the calibration button again. Calibration will

end and charging will begin.

Troubleshooting

• If the lamps blink when no battery is inserted: the MH-21 has malfunctioned. Unplug

the charger immediately and contact a Nikon service representative.

• If the calibration and charge lamps all ﬂ ash at once when a battery is inserted: a

problem occurred during charging. Remove the battery and unplug the charger im-

mediately, then contact a Nikon service representative.

1 2 ... 276 277 278 279 280 281 282 283 284 285 286 287 288

Keine Kommentare

Nikon D2Xs Bedienungsanleitung Seite 281