Nikon INLINE XR Bedienungsanleitung PDF herunterladen (Seite 4)

(3) Adjustment of the ri escope

Sighting through the ri escope, align the ri e with your aiming point on the target and shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and windage as follows:

• If the bullet hits under the aiming point, turn the elevation adjustment turret (counter-clockwise) in the direction of the arrow marked “U” for up. If the bullet hits high, turn the elevation adjustment turret (clock-

wise) in the direction of the arrow marked “D” for down.

• If the bullet hits to the right of the aiming point, turn the windage adjustment turret (clockwise) in the direction of the arrow marked “L” for left. If the bullet hits to the left of the aiming point, turn the windage

adjustment turret (counter-clockwise) in the direction of the arrow marked “R” for right.

• After the reticle has been adjusted to the point of impact, replace the turret cap for both the windage and elevation adjustment turrets.

(4) Zero setting of adjustment turrets

The elevation adjustment and windage adjustment turrets have a retracting system. After the reticle has been adjusted to the point of impact, pull out the elevation adjustment or windage adjustment turret. The

turret can now be turned freely. Align the zero number to the index line to set the zero setting, and then release the turret. The turret automatically retracts to the original position.

Note:

• The windage and elevation scales of the INLINE XR Ri escope 3-9×40 are calibrated in divisions of 1/4 minute of angle with a click at intervals of 1/4 minute of angle (1 division).

• When adjusting the reticle to the point of aim, remember that 1 minute of angle equals approximately 1 in (2.54 cm) at 100 yd (91.44 m).

Therefore, if the impact point is 2 in (5.08 cm) low and 1 in (2.54 cm) right at 100 yd (91.44 m) Parallax Setting, you should adjust 2 minutes of angle up and 1 minute of angle left.

In the case of 50 yd (45.72 m) Parallax Setting, the adjusting value is 2×. In the case of 75 yd (68.58 m) Parallax Setting, the adjusting value is 1.5×.