Nikon KeyMission 360 Bedienungsanleitung PDF herunterladen (Seite 29)

Using SnapBridge 360/170

4 Press and hold down the movie button

(about 7 seconds) on the camera.

• Press and hold down the movie button until the

status lamps flash green at the same time, even if

you hear the startup sound.

• The status lamps flash green at the

same time for a while and then

alternately flash green (the camera is

in pairing standby mode).

5 Tap the camera name when it is displayed on

the screen.

• For iOS:

When you tap the camera

name, a dialog explaining the

procedure is displayed.

Confirm the details and tap

Understood.

When the accessory selection

screen is displayed, wait for the

Bluetooth icon at the top right

corner of the screen to change

from white to gray, and then

tap the camera name again. It

may take a while before the

camera name is displayed.

• If pairing is successful, the

screen shown on the right is displayed.

• If pairing fails, the status lamps flash red six times at the

same time. When a message indicating that pairing has

failed is displayed on the screen, tap OK and repeat the

pairing procedure by following “When You Cannot Pair

with a Smart Device” (A18).

KeyMission 360_XXXXXXXX

Select the camera name from the list.

The camera consists of the model name

followed by an underscore and the serial

number. The serial number is printed on a label

on the camera.

Choose a camera for pairing

Pairing with the Camera

Select An Accessory

• Following the on-screen instructions, select

the camera name.

Cancel

UnderstoodUnderstood

KeyMission 360_XXXXXXXX

Pairing with the Camera

KeyMission 360

Connect

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Nikon KeyMission 360 Bedienungsanleitung Seite 29

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Unterwasserkameragehäuse Nikon KeyMission 360