Nikon KeyMission 360 Bedienungsanleitung PDF herunterladen (Seite 25)

Getting Started

5 When the screen shown on the right is

displayed, tap the camera name.

• For iOS:

When the accessory selection screen is displayed after

tapping the camera name, wait for the Bluetooth icon at the

top right corner of the screen to change from white to gray,

and then tap the camera name. It may take a while before

the camera name is displayed.

• If pairing is successful, the screen shown on the right is

displayed. Follow the on-screen instructions.

• If pairing is successful, the smart device is automatically

paired simply by starting the SnapBridge 360/170 app when

the camera is turned on next time (except when unpairing

using the menus below or the camera’s firmware is updated).

- a Connect M Connection options M End pairing

- c Camera M Camera settings M Reset all

- c Camera M Camera settings M Network menu M Restore default

settings

• If pairing fails, the status lamps flash red six times at the same time. When a message

indicating that pairing has failed is displayed on the screen, tap OK and repeat the

procedure from step 1.

For NFC-compatible Android Devices

1 Prepare for pairing (A9).

• Make sure that the camera is off (the power-on lamp is off).

2 Enable Bluetooth, Wi-Fi, and NFC on the smart device.

• Do not pair from the Bluetooth setting screen of the smart device.

3 Install the SnapBridge 360/170 app.

Connect to Camera

Camera name

KeyMission 360_xxxxxxxx

Connect to Camera

Connected to KeyMission 360_xxxxxxxx

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

Keine Kommentare

Nikon KeyMission 360 Bedienungsanleitung Seite 25