Nikon KeyMission 360 Bedienungsanleitung Seite 24

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 64
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 23
10
Getting Started
Initial Pairing
Perform initial pairing in the following situations:
When pairing for the first time after purchasing the camera
When pairing for the first time after updating the camera’s firmware
For iOS or NFC-incompatible Android Devices
1 Prepare for pairing (A9).
Make sure that the camera is off (the power-on lamp is off).
2 Enable Bluetooth and Wi-Fi on the smart device.
Do not pair from the Bluetooth setting screen of the smart device.
3 Install and start the SnapBridge 360/170 app.
4 Press the movie button or photo
button on the camera to put it into
pairing standby mode.
When the status lamps flash green at the same
time for a while and then alternately flash green,
the camera enters pairing standby mode.
If the camera remains in pairing standby mode for
about 4 minutes, it turns off (the power-on lamp
turns off) automatically. If the camera turns off
during the pairing procedure, press the movie
button or photo button on the camera to put it
into pairing standby mode.
* If the camera does not enter pairing standby
mode even after pressing the movie button or photo button, press and hold the
movie button for about 7 seconds while the camera is off.
Status lamps
Seitenansicht 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare