Nikon KeyMission 360 Bedienungsanleitung Seite 16

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 101
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 15
xvi
Introduction
<Important> Notes About Shockproof, Waterproof, and Dustproof
Performance and Condensation
Notes About Operating Temperature, Humidity, and
Condensation
The operation of this camera has been tested at temperatures from −10°C to +40°C
(14°F to 104°F).
When you use the camera in cold climate regions or at high altitudes, observe the
following precautions.
Battery performance deteriorates temporarily when cold. Keep the camera and
batteries warm under your clothing before use.
Environmental conditions that are likely to cause condensation
Fogging (condensation) may occur on the inside of the lenses, lens protectors, or
underwater lens protectors depending on environments of sharp temperature
changes or high humidity, or the condition of the camera, such as described below.
This is not a malfunction or defect.
The camera is suddenly immersed in cold water after being in a hot place on land.
The camera is brought to a warm place such as inside a building after being in the
cold outdoors.
The battery-chamber/memory card slot cover is opened or closed in a high-
humidity environment.
The camera, lens protector, or underwater lens protector are still wet when they are
attached to each other.
The camera is used for an extended period of time in a low-temperature
environment.
Reducing condensation
Open the battery-chamber/memory card slot cover, put the camera and a
commercially-available desiccant in a container such as a plastic bag, and seal the
container.
Condensation is less likely to occur if the humidity inside the camera is reduced.
Avoid storing the camera in places where the camera may become hot (such as
places exposed to direct sunlight) before using it underwater.
Taking the camera underwater while it is hot causes condensation due to sudden
changes in temperature.
Clearing the fogging
Turn off the camera and open the battery-chamber/memory card slot cover while
in a place where the ambient temperature is stable (avoid places with high
temperature, high humidity, sand, or dust).
To clear the fogging on the lens, remove the battery and memory card, and leave
the battery-chamber/memory card slot cover open to allow the camera to adjust
to the ambient temperature. When a lens protector or underwater lens protector is
fogged, remove the protector, and attach it to the camera again after the fogging
has cleared.
Seitenansicht 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 100 101

Kommentare zu diesen Handbüchern

Keine Kommentare