Nikon Fantasea FD-50N Bedienungsanleitung PDF herunterladen (Seite 12)

Preparation of Housing Before the Dive

Make Common or Required Camera Settings:

Prior to inserting camera in housing, it is recommended that Menu option settings be

made according to the preferences of the user. Most of these choices are ones that will

remain unchanged for most of the time while diving, and therefore it will be more

convenient and less time consuming to make the settings prior to diving.

Mount Housing Port:

Clean & Lubricate Port O-ring [for Port O-ring only]

1. In order to properly maintain the Port O-ring you must periodically

remove port O-ring from channel using only your fingers.

2. Push and lift the O-ring from its channel.

3. Do NOT use any sharp instruments, such as knives or dental picks, to

remove O-ring. You may accidentally cut the O-ring causing a potential

leakage.

4. Inspect the O-ring visually and by feel for any cuts, nicks, flat spots,

stretching, or any debris, such as sand, dirt, lint, hair, or other matter that

could compromise the integrity of the seal.

5. Clean O-ring by soaking in fresh water until all debris is removed.

6. Dry O-ring with a soft clean cloth. Be careful it does not leave any lint on

the O-ring.

7. Lubricate the O-ring with the supplied silicone grease. Do not over-grease

the O-ring. It only requires enough grease to allow it to slip into place and

make a seal. It should be slippery and shiny but without any abundance or

build-up of grease. A teardrop amount is usually sufficient for proper

lubrication.

8. Inspect the O-ring channel for any debris or foreign matter that could

damage the O-ring or cause it to lose its seal.

9. Clean the O-ring channel using a damp cloth or Q-tip. Be careful not to

leave any lint behind.

10. Replace the O-ring in the channel by lifting it over the end of the port until

it sits in its channel. Be sure the O-ring is not twisted or deformed and out

of position in any way.

11. Mount the port on the housing body by aligning the threads on the end of

the port with the mount on the housing and screwing clockwise until it is

FULLY screwed in place.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Keine Kommentare

Nikon Fantasea FD-50N Bedienungsanleitung Seite 12