Nikon WIRELESS KEYPAD KIT HMSC7075 Bedienungsanleitung Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 9
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
4
Installing Your Wireless Keypad
Your module can either be mounted on a wall or sit on a horizontal surface using the included tabletop mount
adapter.
Wall Mount Your Wireless Keypad
Warning: When mounting near a window, drilling too close to the glass could break the glass and possibly cause it to
shatter. The window extends deeper into the frame than can be seen; therefore, ensure your screw is beyond the
glass before drilling.
1 Using the holes on the drilling template found later in this guide, mark the position of
the holes to be drilled.
For drywall or other composite surfaces use a 7/32" drill bit. Drill a hole for each of
the mounting screws and insert a plastic wall anchor into each hole.
For other solid surfaces, use a 1/16" drill bit. Drill a pilot hole for each of the
mounting screws.
2 Using the screws provided, secure the module to the wall. When mounting the screws to the wall, leave 1/16"
(1.6 mm) space between the screw head and the wall. Using the mounting holes, slide the module down on to
the screws until it is firmly seated.
Wall Mount Drilling Template
Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, Motorola recommends that you pre-drill ½ inch
deep pilot holes with a drill bit slightly smaller than the module mounting screws before securing the module to the
surface. When mounting a module on soft surfaces like sheetrock, use an awl to punch holes in the material slightly
smaller than the plastic anchors included in the hardware mounting kit.
The illustration is drawn to a one-to-one scale, which means that it provides the exact dimensions required to mount
the unit.
Drill Holes In
These Positions
3.00 in
1.6 mm (1/16 inch
)
maximum
Seitenansicht 3
1 2 3 4 5 6 7 8 9

Kommentare zu diesen Handbüchern

Keine Kommentare