Nikon DLP 837 Series Bedienungsanleitung PDF herunterladen (Seite 9)

1. Basic Setup and Operation 9

737 and C9 series.

Flip open cover to

use buttons on the

front panel.

TV Control Panel

Buttons on the control panel duplicate some keys on

the remote control.

Refer to • upper labels when no TV menus are dis-

played.

Refer to • lower labels when using TV menus or after

activating a special function.

System Reset

If the TV fails to respond to the remote control, the

control-panel buttons, or will not power on/off, perform

System Reset. Recent setting changes made before

using System Reset may be lost.

To perform System Reset, press and hold the

POWER

button on the control panel for ten seconds.

Panel-Lock Release

To • release the Panel Lock from the TV control

panel, press and hold the

ACTIVITY

button on the

control panel for ten seconds. You can release the

Panel Lock with the TV powered either on or off.

To activate the Panel Lock, use the • Lock menu,

page 44 .

Controls on 737 and C9 series TVs. 837 series controls

are similar and are located next to the

STATUS

indicator.

TV Controls, continued

If You Power Off the TV by Mistake

1. Press

POWER

again, within about 60 seconds,

to have the TV come back on immediately.

2. If the status indicator starts rapidly blinking

green (about 60 seconds after you shut off

power), wait a few moments for the status indi-

cator to stop blinking and press

POWER

to turn

the TV on again.

Key

Off

Steady On

Slow Blinking

Fast Blinking

LED Color TV Condition Additional Information

None

TV is powered off.

Normal operation.

Green

TV is powered on.

Normal operation.

Green

TV powered off, auto-on TV Timer

is set.

Normal operation. TV can be turned on at any time.

Green

TV just powered off and lamp is

cooling.

LED starts to blink 60 seconds after turning off TV. TV can be

turned back on before blinking starts or after blinking stops, but

not while the indicator is blinking. Normal operation.

Yellow

Lamp failure1. Replace the lamp. See “Lamp-Cartridge Replacement and

Cleaning” on page 69 .

No lamp installed.2.

Red

Lamp access door is open or not

secure.

TV will not operate until lamp access door is secured. See

“Lamp-Cartridge Replacement and Cleaning” on page 69 .

Red

TV may require service.

Turn off the TV and unplug the set from the AC power source.

Wait one minute and then plug the set back in. See Appendix E .

If the red LED is still on, contact your dealer or a Mitsubishi

Authorized Service Center. Go to www.mitsubishi-tv.com or call

1-800-332-2119 to receive Authorized Service Center information.

STATUS Light

POWER

STATUS

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

Nikon DLP 837 Series Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern