Nikon DLP 837 Series Bedienungsanleitung PDF herunterladen (Seite 10)

10 1. Basic Setup and Operation

Setting Up Other Inputs

Connect your devices to the TV, making note of

which TV input jack is used for each device. See

“TV Connections,” page 14 , for recommendations.

Power on the devices to ensure detection.

Power on the TV.

The TV will display the New Device Found screen

for each new connection it detects Learn more

about Auto Input/Auto Output Sensing on the

opposite page .

Select the device type if the device is not recog-

nized automatically.

Sample New Device

Found screen.

Important Note for NetCommand IR Users

837 Series. Be sure to select the correct device

type here. Although you can change the device type

later in the Inputs > Name menu, any “learned” Net-

Command IR codes will be erased when you make

the change.

837 Series.

You can perform Net Command IR

“learning” after selecting the device type or at a

later time when convenient. To perform now, high-

light NetCommand and press

ENTER

. See

“Initial

NetCommand Setup,” page 47 or “Setting Up A/V

Receiver Control,” page 52 .

Press

BACK

to close the New Device Found screen.

The TV will then display the New Device Found

screen for the next connection it finds.

Using the ANT (Antenna) Input

If using an antenna or direct cable service (no cable

box), connect the incoming coaxial cable to the TV’s

ANT

input. Refer to page 18 .

You must save channels to memory with a channel scan

to enable reception of all available high-definition and

standard-definition digital channels. The channel scan

will search for channels available locally. If you skip this

step, the TV will receive only analog channels.

M emorizing Channels with Channel Scan

For the ANT input

To start channel memorization

Power on the TV.

Press

and open the Initial > Channel menu.

Start channel memorization from the Initial > Channel

menu.

Press

ENTER

to enter the menu.

Select

Ant Air if connected to an

over-the-air antenna. Select Ant

Cable for direct cable.

Highlight

Scan and press

ENTER

Channel memorization may take up

to 15 minutes to complete.

To stop channel memorization before completion,

press

CANCEL

Use the Initial > Channel > Edit menu ( page 39 ) for

additional channel options, such as adding or deleting

channels from memory.

Settin g Up TV Inputs

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

Nikon DLP 837 Series Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern