Nikon LS-4500AF Bedienungsanleitung PDF herunterladen (Seite 40)

Nikon

Film Scanner LS-4500AF User's Manual

Remarks

• The maximum number of SCSI devices that can be connected to one

computer is eight. In the case of a host computer with a built-in SCSI

hard disk or built-in CD-ROM, note that SCSI ID numbers have been

pre-assigned for the host CPU and the SCSI devices.

• The SCSI cable must not be extended beyond a total length of 19 feet (6

meters), or else failure may result.

• If you use the type of terminator that is inserted between the SCSI cable

and SCSI interface connector, install a terminator independent of the

other SCSI connector of the LS-4500AF.

• Terminators must be attached to the devices located at both ends of the

SCSI chain.

If the host computer is a Macintosh, the Macintosh itself will provide

termination at one end of the chain.

If the host computer is an IBM PC/AT or compatible, equipped with a

SCSI board, the SCSI board itself will present termination at one end of

the chain.

Note that when a SCSI chain connection is made inside a computer, the

end of the SCSI device inside the computer will become the end

terminal.

• Before installing a SCSI board, be sure to read the user’s manual

provided with the board. The numbers for the I/O address, interrupt

level (INT) and DMA channel might be used for other interface boards

and peripheral devices. If so, change them as explained in the manual.

4. Connecting the LS-4500AF

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 73 74

Keine Kommentare

Nikon LS-4500AF Bedienungsanleitung Seite 40