Nikon Coolpix 300 Bedienungsanleitung PDF herunterladen (Seite 96)

Connections : Making a SCSI Connection

✔ Caution: Choosing a SCSI ID that has been assigned to another

device will prevent communication between the COOLPIX 300 and your

computer and could result in loss of data from your hard disk. Be sure that

the number you choose for the COOLPIX 300 is not already assigned to

another SCSI device.

Once you have chosen an SCSI ID for the COOLPIX 300, use the stylus to

choose a setting for the camera’s built-in terminator. Because the

COOLPIX 300 has only one SCSI connector, the camera will be the last

item in the SCSI chain. In most circumstances, therefore, the terminator

should be set to ON.

Note: You will need to turn the camera off and then on again before any

changes to the SCSI settings will be put into effect. After turning the

camera off, wait four or five seconds before turning it on again. Once the

camera has been turned back on, the new SCSI ID will be displayed in

square brackets next to ID in the window shown above.

To discard any changes and return to the setup menu, press CANCEL.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 115 116

Keine Kommentare

Nikon Coolpix 300 Bedienungsanleitung Seite 96