Nikon Coolpix 300 Bedienungsanleitung PDF herunterladen (Seite 95)

Connections : Making a SCSI Connection

Making a SCSI Connection

If your computer supports SCSI, you can achieve high-speed data transfer

using the optional SS-E300 SCSI cable available separately from Nikon.

This section describes how to set your camera’s SCSI ID and how to

connect your camera to a computer using the SS-E300.

Setting the Camera’s SCSI ID

Before connecting the COOLPIX 300 to your computer using the optional

SCSI cable, you will need to check that the camera’s SCSI settings are

compatible with such other SCSI devices as may be attached to your

computer. Select INTERFACE from the second page of the COOLPIX

300’s setup menu. The following window will be displayed.

Using the stylus, highlight an ID number for the COOLPIX 300 that does

conflict with other devices that are already connected to the computer’s

SCSI chain. As the ID numbers “0” and “7” are often assigned to the host

computer or one of the computer’s drives, it is recommended that the ID

number you choose for your camera be between “1” and “6” (in the case of

Macintosh computers, be aware that in most cases “0” has already been

assigned to the internal hard disk, “3” to the CD-ROM drive, and “7” to the

computer’s CPU).

MENU SETUP I/F

« SCSI »

ID [6]

0 1 2 3

4 5 6 7

TERMINATOR ON OFF

1/2

Current SCSI ID

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 115 116

Keine Kommentare

Nikon Coolpix 300 Bedienungsanleitung Seite 95