Nikon HT1000 Bedienungsanleitung Seite 20

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 61
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 19
E-20
The rear foot height can be changed. Rotate the rear foot to the desired
height, but the vertical distance from the bottom to the desk or floor
should be 1" (25 mm) to make the projector horizontal on the flat sur-
face.
PC CONTROL
RGB IN
DVI-D IN
SG TRIGGER
VIDEO IN
S-VIDEO IN
S-VIDEOS-VIDEO
RGB/DVIRGB/DVI
VIDEOVIDEO
AUDIO INAUDIO IN
COMPONENT
Y
Cb/Pb
Cr/Pr
Up
Down
Up
Down
CAUTION:
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as gripping the tilt-foot or hanging on the wall can
cause damage to the projector.
Zoom
Use the Zoom lever to fine adjust the image size on the screen
Focus
Use the Focus ring to obtain the best focus.
Correcting the Horizontal and Vertical Key-
stone Distortion (3D Reform)
Use the 3D Reform feature to correct keystone (trapezoidal) distortion
to make the top or bottom and the left or right side of the screen longer
or shorter so that the projected image is rectangular.
Two options are available for correcting procedures.
You can save adjustment settings by using the 3D Reform Save option
on Setup (See page E-42).
Keystone
Iris
Use the Iris lever underneath the lens to adjust the brightness and the
contrast optically.
Iris lever
Screen
Projected image
Screen
The CORNERSTONE adjustment screen is displayed.
NOTE: Press the 3D REFORM button to toggle between "Cornerstone" and "Key-
stone."
4. Use the SELECT
왖왔왗왘
button to select one icon which points in
the direction you wish to move the projected image frame.
(The drawing shows the upper right corner.)
3. Press the 3D REFORM button on the remote control.
1. Press the SELECT
왗왘
button to adjust the horizontal keystone.
2. Press the SELECT
왖왔
button to select "Vertical".
3. Press the SELECT
왗왘
button to adjust the vertical keystone.
4. After completing, press the ENTER button. This will return to the menu
screen.
Cornerstone
1. Project an image so that the screen is smaller than the area of the
raster.
2. Pick up any one of the corners and align the corner of the screen
with the one of the image.
Seitenansicht 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 60 61

Kommentare zu diesen Handbüchern

Keine Kommentare