Nikon MSV-01 Bedienungsanleitung PDF herunterladen (Seite 19)

Preparation—Installing and Charging the Battery Pack

Using the COOLWALKER MSV-01 from an AC Power Supply Source

• To use your MSV-01 from an AC power source, connect the AC adapter and turn the power switch on.

• Charging is not performed when the MSV-01 is on with the AC adapter connected.

Removing and Installing the Battery Pack

• Before removing the battery pack make sure that the MSV-01 is turned off and the AC adapter is dis-

connected.

• When removing or attaching the battery pack, always observe the correct procedure described in this

manual to avoid damaging the battery terminals.

• Do not touch the battery pack terminals to avoid damaging them and prevent them from becoming

dirty.

• Do not leave unattended or transport the MSV-01 with the battery pack removed.

• Do not remove the battery pack when using the MSV-01 from an AC power supply source. If you acci-

dentally connect the AC adapter to the MSV-01 with the battery pack removed, the power-on lamp

will light up (orange). Make sure that the MSV-01 is off, disconnect the AC adapter and attach the

battery pack.

The AC Adapter

• Accidental disconnection of the AC adapter while the MSV-01 is turned on may damage the device.

When using the device, be careful not to disconnect the AC adapter.

• Be sure to read and follow the precautions in the "For Your Safety" ( i-iii) section and notes on

using the AC adapter ( 59) in this manual.

The Battery Pack

• When transporting or storing a spare battery pack, place it in the supplied case.

• On handling the battery pack, refer to the Li-ion Polymer Battery EN-EL6 manual. When installing or

removing the battery pack, be sure to read and follow the precautions in the "For Your Safety"

( i-iii) and "Notices" ( iv - vi) sections, as well as notes on using the battery pack in the

"Batteries" ( 60) section in this manual.

(2) Open the interface connector cover, and connect

the supplied AC adapter to DC-in connector (

➈).

Plug the AC adapter into an outlet (

➉).

(3) Charging will begin immediately.

While the battery is charging, the power-on lamp

flashes in orange. Charging is complete when the

orange power-on lamp stops flashing.

An exhausted battery can be fully charged in

about 4.5 hours.

(4) Remove the AC adapter, while the MSV-01 is still

off.

➈

➉

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 79 80

Keine Kommentare

Nikon MSV-01 Bedienungsanleitung Seite 19