Nikon 9000ED Bedienungsanleitung PDF herunterladen (Seite 72)

Troubleshooting

If the scanner fails to function as expected, check the problems described below before con-

sulting the original retailer or Nikon service representative. For more information on solving

the problems listed here, refer to the page numbers in the rightmost column.

Problem Possible cause

Scanner will not

turn on (status LED

does not light)

• Scanner is off

Turn the scanner on

• Power cable is not properly connected

Return the power switch to the off position and reconnect the power

cable.

• Outlet is not receiving power

Plug another device into the outlet to determine whether the outlet is

working properly.

—

Status LED ﬂ ickers

(scanner not con-

nected to computer,

or computer off)

• Scanner hardware malfunction

Turn the scanner off and disconnect it from the computer. Wait ﬁ ve

seconds and turn the scanner on again. If the problem persists, con-

tact a Nikon service representative.

—

Status LED ﬂ ickers

(scanner connected

to computer)

• Scanner hardware malfunction or communications error

Turn the scanner and computer off and disconnect the scanner. Wait

ﬁ ve seconds and turn the scanner on again. If the status LED ﬂ ickers

when the scanner is turned on, a scanner hardware malfunction has

occurred. Contact the original retailer or a Nikon service representa-

tive. If the status LED blinks and then glows steadily, turn the scanner

off and reconnect it to the computer. After waiting ﬁ ve seconds, turn

the scanner on and restart the computer. If the status LED ﬂ ickers

when the computer is restarted, try the following:

• Disconnect all other devices using the same interface as the scanner

• Reinstall Nikon scan

• Update the IEEE 1394 device drivers (Windows only)

• Update the scanner device drivers (Windows only)

22, 41

5, 22

10–19

70–72

65–69

74–75

Computer does not

recognize scanner

• Scanner is off

Turn the scanner on.

• Scanner turned on with holder inserted

After removing the holder, turn the scanner off and then on again.

• Interface cable not correctly connected

Turn the scanner off and reconnect the cable.

• Computer does not meet minimum system requirements

Use a system that meets the requirements.

24, 41

22, 41

10, 15

Poor quality scans

• Film is not properly inserted in holder

Eject the holder and reinsert the ﬁ lm.

• Scanner or holder moved during scanning

Do not use the scanner in locations subject to shock or vibration. Fail-

ure to observe this precaution could result in scanner malfunction.

• Scan window settings require adjustment

Adjust settings or use factory defaults. For more information, see the

Nikon Scan Reference Manual.

• Glass in optional glass-covered holder is dirty

Use a blower to remove dust, a soft cloth to remove other stains.

25–29,

33–38

—

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 88 89

Kommentare zu diesen Handbüchern

Keine Kommentare

Nikon 9000ED Bedienungsanleitung Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikroskope Nikon 9000ED