Nikon 9000ED Bedienungsanleitung PDF herunterladen (Seite 35)

Place ﬁ lm in the holder

FH-835S Holder for 35-mm Film

The FH-835S can be used with one or two strips of 35-mm ﬁ lm. Each strip can be up to

six frames long.

2.1

Open the holder

Insert your ﬁ ngers through the holes

in the bottom half of the holder and

undo the latches, then open the

holder.

Latches

2.2

Insert ﬁ lm

Place ﬁ lm in the holder with the reﬂ ec-

tive ﬁ lm base up and the matte emulsion

surface down.

Inserting Film

Align the ﬁ rst frame in each strip with

an aperture at the left end of the hold-

er. Leaving the apertures at the left

end of the holder uncovered or cover-

ing them with a masking sheet could

cause scanning errors or interfere with

accurate color reproduction.

Use only one type of ﬁ lm; do not mix

negatives with positive ﬁ lm.

Inserting Film

Do not place ﬁ lm or masking sheets so that they protrude from the holder or overlap the ﬁ lm guides.

Failure to observe this precaution could cause the holder to jam in the scanner.

“Film Base”/”Emulsion Surface”

When ﬁ lm is examined under bright light, the image on the emulsion surface will be in slight relief, with

bumps and hollows where the image has been developed. The opposite surface (the ﬁ lm base) will be

reﬂ ective and smooth. Insert ﬁ lm with the base up.

Direction of

insertion

Thumbnails

displayed in

order shown

Arrow

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 88 89

Keine Kommentare

Nikon 9000ED Bedienungsanleitung Seite 35