Nikon 9000ED Bedienungsanleitung PDF herunterladen (Seite 33)

Windows 98 SE

If the dialog shown at right appears the ﬁ rst time the scanner is

connected and turned on, the IEEE 1394 driver update has not been

completed. Update the IEEE 1394 drivers as described in “Updat-

ing the IEEE 1394 Drivers (Windows 98 SE Only): The ‘Insert Disk’

Dialog” (

65).

Windows 2000 Professional

A “Digital Signature Not Found” dialog will be displayed the ﬁ rst

time the scanner is connected and turned on following installation

of Nikon Scan. Click Yes to register the scanner with Windows.

Step 1 — Turn the Scanner On

Before turning on the scanner for the ﬁ rst time, make sure that Nikon Scan is installed on the

computer and that the power and IEEE 1394 cables are connected. For information on install-

ing Nikon Scan and connecting the cables, see “Setup” (

7).

Turn the computer on

Turn the computer on and wait for the operating system to start up.

Turn the scanner on

The status LED will blink for about two minutes while the scanner initializes. The status

LED will stop blinking when initialization is complete.

Scanner off

Status LED off

Scanner on

Status LED blinks Status LED on

If the Status LED Flickers

If the status LED ﬂ ashes quickly (about ﬁ ve times a second), turn the scanner off, wait at least ﬁ ve sec-

onds, and turn the scanner on again. If the problem persists, see “Troubleshooting” (

63).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 88 89

Keine Kommentare

Nikon 9000ED Bedienungsanleitung Seite 33