Nikon 9000ED Bedienungsanleitung PDF herunterladen (Seite 31)

Step 3 — Connect the IEEE 1394 Cable

Make sure that the scanner is off

Connect the IEEE 1394 cable

Connect the supplied IEEE 1394 cable as shown below. Connect the scanner directly to

the computer; do not connect the cable via an IEEE 1394 hub or adapter.

Connecting the IEEE 1394 Cable

Connect the cable as shown. When connecting the cable to the computer, use a six-pin

IEEE 1394 (Firewire) terminal like that shown in the cross-section below. Attempting to

insert the connectors in another orientation or using the wrong connector could not only

damage the connector, but also the scanner or computer.

Connecting the Scanner

• Do not connect or disconnect IEEE 1394 cables while Nikon Scan is starting or after it has started.

• The scanner may not function as expected when used with other IEEE 1394 devices. Should the scan-

ner not function as expected, use the scanner with all other IEEE 1394 devices disconnected. Do not

connect two or more scanners to the computer simultaneously.

• Do not connect or disconnect USB or IEEE 1394 interface cables or operate camera control software for

digital cameras connected via USB while the scanner status LED is blinking.

• After disconnecting the cable, wait a few seconds before connecting it again.

Computers with Four-Pin Connectors

The supplied IEEE 1394 cable can not be connected to computers with a four-pin DV connector. Use a

cable with one six-pin and one four-pin connector or a six-to-four pin adapter.

Align rounded edge of connector (circled above at

right) with matching curve on scanner or computer IEEE

1394 (Firewire) terminal (above at left).

Six-Pin IEEE 1394 (Firewire) Terminal and Connector (Cross Section)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 88 89

Keine Kommentare

Nikon 9000ED Bedienungsanleitung Seite 31