Nikon WT-2 Bedienungsanleitung PDF herunterladen (Seite 21)

Controlling the Camera: PTP / IP Mode

In PTP / IP mode, a camera equipped with a WT-2 can be controlled over a wire-

less network from a computer running Nikon Capture 4 version 4.2 or later

(available separately) and photographs saved directly to the computer hard

disk. Before the camera can be controlled from the computer, wireless set-

tings must be adjusted appropriately and the camera and computer must be

“paired” using special software. The principal steps involved in using PTP / IP

mode for the ﬁ rst time are as follows:

2—Setup Using the Connection Wizard ............ 15–16

3—Pairing......................................................... 17–19

4—Connecting to the Computer ........................... 20

5—Controlling the Camera.................................... 21

1—Installing Pairing Software ................................ 39

Steps 1–3 can be omitted once the WT-2 has been set up for connection to a

particular computer.

Installing Pairing Software

The Wireless Connecting Utility supplied with the WT-2 must be installed on

the host computer before it can be paired with the camera. See page 39 for

more information.

Wireless Network Settings

For information on adjusting wireless network settings without using the Connection

Wizard, see “Menu Guide” ( 26–31). See page 25 for information on loading set-

tings ﬁ les created with a computer.

Firewalls

PTP / IP mode uses UDP port 5353. It may be necessary to adjust ﬁ rewall settings before

connecting to a computer behind a ﬁ rewall.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 186 187

Keine Kommentare

Nikon WT-2 Bedienungsanleitung Seite 21