Nikon SBV5121 Bedienungsanleitung PDF herunterladen (Seite 16)

Introduction Installation Troubleshooting Glossary License

SBV5121 VoIP Cable Modem User Guide 8

Installation and Configuration

To install and configure your VoIP cable modem for a single PC running Microsoft Windows, we recommend using

the

Installation

Assistant.

You can start the Installation

Assistant from the Main Menu on the SBV5121 VoIP Cable

Modem

CD-ROM. In most cases, the Installation

Assistant automatically configures your VoIP cable modem.

Otherwise, to install and configure your VoIP cable modem:

1 Connect the cables as described for your situation:

• “Cabling and Startup for a Single User” on page 8

• “Cabling for Multiple Users” on page 33

2 If you are using the USB port only, go to “Setting Up a USB Driver” on page 10. Ethernet users can skip this

step.

3 Configure TCP/IP and verify the IP address for your computer as described for your situation:

• For Windows computers, see “Configuring TCP/IP” on page 20

• Refer to your Macintosh or UNIX user manual for information regarding TCP/IP and IP address

configuration.

Cabling and Startup for a Single User

Allow some time (5 to 30 minutes) to power up the first time because the SBV5121 VoIP cable modem must find

and lock on the appropriate channels for communications.

1 Be sure your computer is on and the VoIP cable modem is unplugged.

2 Connect one end of the coaxial cable to the cable outlet or splitter. Connect the other end of the coaxial cable

to the CABLE connector on the VoIP cable modem. Hand-tighten the connectors to avoid damaging them.

3 Insert the SBV5121 VoIP Cable Modem CD-ROM into your CD-ROM drive.

4 If you are using an AC power adapter, plug the adapter into the +12VDC connector on the VoIP cable modem

and an unswitched AC electrical outlet.

If you are using an Uninterruptible Power Supply (UPS), plug the power cord into the +12VDC connector on

the VoIP cable modem and into the UPS. Plug the UPS into an unswitched AC electrical outlet.

This turns on the SBV5121 VoIP cable modem. You do not need to unplug it when not in use.

To electrical outlet or UPS (step 4)

To cable outlet (step 2)

Always connect coaxial

cable to the wall outlet first.

CABLE

+12VDC

USBTEL 2TEL 1

ETHERNET

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 57 58

Keine Kommentare

Nikon SBV5121 Bedienungsanleitung Seite 16