Nikon COOLPIXS9100RED Bedienungsanleitung PDF herunterladen (Seite 208)

196

Maximizing Camera Life and Performance

Caring for the Camera

Cleaning

Do not use alcohol, thinner, or other volatile chemicals.

Storage

Turn the camera off when not in use. Be sure that the power-on lamp is off before

putting the camera away. Remove the battery if the camera will not be used for an

extended period. Do not store the camera with naphtha or camphor moth balls, or

in any of the following locations:

• Next to equipment that produces strong electromagnetic fields, such as

televisions or radios

• Exposed to temperatures below –10°C (14°F) or above 50°C (122°F)

• Places that are poorly ventilated or subject to humidity of over 60%

To prevent mold or mildew, take the camera out of storage at least once a month.

Turn the camera on and release the shutter a few times before putting the camera

away again.

Lens

Avoid touching glass parts with your fingers. Remove dust or lint with a blower

(typically a small device with a rubber bulb attached to one end that is

pumped to produce a stream of air out the other end). To remove fingerprints

or other stains that cannot be removed with a blower, wipe the lens with a soft

cloth, using a spiral motion that starts at the center of them and working

toward the edges. If this fails, clean the lens using a cloth lightly dampened

with commercial lens cleaner.

Monitor

Remove dust or lint with a blower. To remove fingerprints and other stains,

clean the monitor with a soft, dry cloth, being careful not to apply pressure.

Body

Use a blower to remove dust, dirt, or sand, then wipe gently with a soft, dry

cloth. After using the camera at the beach or other sandy or dusty

environment, wipe off any sand, dust, or salt with a dry cloth lightly dampened

with fresh water and dry thoroughly. Note that foreign matter inside the

camera could cause damage not covered by the warranty.

C Notes on the Monitor

• The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic

common to all TFT LCD displays, and does not indicate a malfunction. Images saved using the

product will not be affected.

• Images in the monitor may be difficult to see under bright lighting.

• The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your

Nikon-authorized service representative.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 235 236

Keine Kommentare

Nikon COOLPIXS9100RED Bedienungsanleitung Seite 208