Nikon CL L2 Bedienungsanleitung PDF herunterladen (Seite 14)

Using The Flash:

The Coolpix has a built-in flash, which will illuminate nearby

underwater subjects. For subjects that are farther away, an accessory

slave flash is recommended. (See Below.) A built-in flash diffuser

is supplied which will help achieve a wider and softer light source

thereby providing more coverage and less likelihood of backscatter

(the unattractive snowstorm affect of the flash reflecting off the

suspended particles in the water). Further reduction of backscatter

can be achieved by using an accessory off-camera slave flash. This

will be discussed in more detail.

The need for artificial light to maximize color reproduction is

necessary in nearly all pictures. Therefore it is strongly recommended

that you set the flash mode to Flash Always. This will insure the

flash fires on every exposure regardless of the ambient light conditions.

(Please refer to the camera s instruction manual for more details.)

Outdoor photographers do not have this same concern. There is no

backscatter to be concerned with, and due to the ability of the flash

to travel farther and more effectively in air as compared to in water,

there is normally not a need for an accessory flash to provide proper

illumination for most subjects.

Accessory Slave flash:

If you should use the Coolpix built-in flash as the master, you can

trigger a second slave flash to provide more artificial light when

needed. To do this, you must use an accessory flash that has a slave

feature built in. The flash from the Coolpix must be aimed or bounced

toward the accessory flash's slave sensor, or other fiber optic sensor.

This will trigger the slave to fire in sync with the master flash.

When using an accessory slave flash with fiber optic cable, it is

recommended to black out the internal camera flash. The internal

flash is located near the camera lens and can contribute to backscatter

by illuminating floating particles close to the lens port..

If the sensor of the fiber optic cable is attached to the outside of the

housing directly above the internal flash and taped over with black

tape it will block out the light from the internal flash but transmit

the light pulse to the external slave flash.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19

Keine Kommentare

Nikon CL L2 Bedienungsanleitung Seite 14