Nikon CL L2 Bedienungsanleitung PDF herunterladen (Seite 11)

Underwater photographers will probably want to set the flash

mode to the flash always setting to insure they always have a

flash with every exposure. It is also wise to set the focus mode

to allow the lens to focus in the macro range for capturing great

images of the tiny and exotic subjects that you can find underwater.

Checking the Gasket:

Prior to each closure of the housing the gasket seal should be

visually inspected. If there is any debris present, including dirt,

sand, dust, hair, grease or other matter, it must be cleaned to

insure a proper watertight seal. Cleaning the gasket is a simple

matter of wiping it with a damp, soft cloth to remove the foreign

matter. Be careful the cloth you use does not leave any of its own

material behind as this can also affect the effectiveness of the

gasket. It is not necessary to remove the gasket for cleaning unless

visual inspection determines that there is foreign matter underneath

the gasket as well. If this occurs, be sure the surface of the housing

is also clean and wiped free of any debris.

Since the gasket on the Fantasea FL-3 and FL-4 are face-

to-face/compression sealed, and is not subject to friction

as it is closed, there is no need to lubricate it. Grease or

any other form of lubrication does not help seal the

housing. It only reduces friction, which is commonly

present if the housing has an O-ring seal. Lubricating the

gasket before use could cause it to slip out of its groove,

and not form a proper seal: therefore no silicon or other

lubricants should be used.

The gasket should also be checked visually for any cracks

or perforations. If any part of the gasket shows signs of

wear or damage, it is imperative that it be changed before

going into the water.

If the gasket is removed from the channel groove it sits

in, be sure to get it completely back into place so it is

properly seated. Starting at one corner, press the gasket

with your finger and feel it seat into its channel groove.

Then continue this procedure continuously in one direction,

round its perimeter, until the entire gasket has been

pressed flat into place. Go over it a second time to be sure

it is properly in place. Then you are ready to clean it, give

it a final visual inspection, and close the housing.

Info:

Gasket

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Keine Kommentare

Nikon CL L2 Bedienungsanleitung Seite 11