Nikon S1200PJ Bedienungsanleitung PDF herunterladen (Seite 209)

Maximizing Camera Life and Performance

Technical Notes and Index

Cleaning

Do not use alcohol, thinner, or other volatile chemicals.

Storage

Turn the camera off when not in use. Be sure that the power-on lamp is off before

putting the camera away. Remove the battery if the camera will not be used for an

extended period. Do not store the camera with naphtha or camphor moth balls, or

in any of the following locations:

• Next to equipment that produces strong electromagnetic fields, such as

televisions or radios

• Exposed to temperatures below –10°C (14°F) or above 50°C (122°F)

• Places that are poorly ventilated or subject to humidity of over 60%

To prevent mold or mildew, take the camera out of storage at least once a month.

Turn the camera on and release the shutter a few times before putting the camera

away again.

• For storing the battery, follow the precautions in “The Battery” (F 3) in

“Maximizing Camera Life and Performance”.

C Notes on the Monitor

• The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic

common to all TFT LCD displays, and does not indicate a malfunction. Pictures recorded using the

product will not be affected.

• White or colored streaks may be visible when bright subjects are framed in the monitor. This

phenomenon, known as “smear,” occurs when extremely bright light strikes the image sensor; it is

characteristic of image sensors and does not indicate a malfunction. Smear may also take the form

of partial discoloration in the monitor during shooting. It does not appear in pictures recorded

with the camera except in the cases of movies and of pictures recorded with Multi-shot 16

selected for Continuous. When shooting in these modes, we recommend that you avoid bright

subjects such as the sun, reflected sunlight, and electric lights.

• Pictures in the monitor may be difficult to see under bright lighting.

• The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your

Nikon-authorized service representative.

Lens

Avoid touching the lens/projector window with your fingers. Remove dust or

lint with a blower (typically a small device with a rubber bulb attached to one

end that is pumped to produce a stream of air out the other end). To remove

fingerprints or other stains that cannot be removed with a blower, wipe the

lens/projector window with a soft cloth, using a spiral motion that starts at the

center of them and working toward the edges. If this fails, clean them using a

cloth lightly dampened with commercial lens cleaner.

Monitor

Remove dust or lint with a blower. To remove fingerprints and other stains,

clean the monitor with a soft, dry cloth, being careful not to apply pressure.

Body

Use a blower to remove dust, dirt or sand, then wipe gently with a soft, dry

cloth. After using the camera at the beach or other sandy or dusty

environment, wipe off any sand, dust or salt with a dry cloth lightly dampened

with fresh water and dry thoroughly. Note that foreign matter inside the

camera could cause damage not covered by the warranty.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 227 228

Kommentare zu diesen Handbüchern

Keine Kommentare

Nikon S1200PJ Bedienungsanleitung Seite 209

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kamerarekorder Nikon S1200PJ